Alan Roberts F3 assessment. Confusing Reading.

Alan Roberts F3 assesment is now online: http://thebrownings.name/WHP034/pdf/WHP034-ADD68_Sony_PMW-F3.pdf

In the report Alan observes the aliasing that I have seen from the camera, in particular the high frequency moire, so no surprise there. But he also measures the noise at -48.5db. Now I don’t have the ability to measure noise as Alan does and I normally respect his results, but this noise figure does not make sense, nor does his comment that the camera has similar sensitivity to most 3 chip cameras. To my eyes, the F3 is more sensitive than any 3 chip camera I’ve used and it’s a lot less noisy. The implication of the test is that the F3 is noisier than the PMW-350. Well that’s not what my eyes tell me. Take a look at the noise graph Alan has prepared. The hump in the noise figure curves at 0db also appears to be dismissed as insignificant, yet it means a greater than 4db difference between what the curve implies the noise figure should be and the measured noise figure. It really doesn’t seem to fit and is very strange. Video amplifiers and processing are normally pretty linear with gain giving a consistent increase/decrease in noise that follows the gain curve. If you read off the noise figures from the graph, the F3 appears to have less noise at +6db gain (-49.5db)  than at 0db (-48.5db). So id we are to believe Alan’s test then we should be using +6db gain or -3db gain (-53.5db) but not 0db, sorry but that just does not add up and to dismiss the 0db noise bump as “not significant” is something I don’t really understand as too me it is significant. Either there is something very strange going on with the F3 at 0db, or there is something up with the test. I suspect the later, perhaps the individual camera had some odd settings, as my F3 is quieter (visually) at 0db than +6db. I would need to check it out on a scope back at home to verify this.

There are also assumptions made about the pixel size and sensor pixel count that are quite wrong. Alan suggests the sensor to be a 12 Mega Pixel sensor, this suggestion is based on Alan’s opinion that the F3 has similar sensitivity to a 2/3″ 3 chip camera, so therefore the pixel size must be similar and the bigger sensor means that it must have 12 MP, yet Sony have published that it is 3.3 mega Pixels (same sensor as FS100). 3.3MP equates to roughly 2422 x 1362 pixels, for a bayer sensor this is a little under the optimum for 1920 x1080 (IMHO) and may explain the aliasing as Sony are probably trying to squeeze every last bit of resolution out of the sensor.

Alans assessment of his zone plate results also concludes that the R, G and B resolutions are the same and that the sensor resolution must be much higher than 2200 x 1240. Well I would not call 2422 x 1362 “much” higher and if this is a bayer sensor (neither admitted or denied by Sony) then the G resolution should be higher than the R and B. So could this be a case of conventional conclusions about an unconventional sensor, or have Sony managed to completely wrong foot Mr Roberts?

An interesting finding was that detail at zero, frequency at +99 and aperture at +20 gives the least aliasing. This is quite different from my own findings and will need further exploration.

The F3 assessment is also missing the usual customary round up from Alan where he suggests whether the camera is suitable for HD broadcast or not. I’m really glad I got my F3 before reading the report as I have seen with my own eyes the beautiful clean images the F3 produces. I strongly recommend anyone considering the F3, but put off buy this report to take a look at the pictures for themselves before making any decisions.

6 thoughts on “Alan Roberts F3 assessment. Confusing Reading.”

  1. Alister it’s more than obvious that Alan Roberts is a technician rather than someone who knows a dam good picture when he sees one. The F3 which I am producing a video review is not only the King of low light but has the cleanest picture by far of any camcorder available today.
    If we had all seen his paper on the Panasonic AF101 once again sales would have suffered, but interestingly enough the BBC still conditionally approve the AF101 despite Alan Roberts damming assessment. Tests only give you half the story.

  2. Hi Alister. Very confusing reading indeed. In your opinion, as long as your are hitting the 50Mbs mark with an external recorder, do you think that the sensor makes it meet the minimum specs for the BBC?

    1. I think the F3+ external recorder should get conditional approval on a per production basis. I’m not sure it would be right to give it general approval as it simply isn’t appropriate for a lot of projects.

  3. Just an update here is Alan’s reply after getting major flack over his AF101 report on DV Doctor…I

    Alan “apologise for my outburst last week. It was unduly vitriolic.

    Here’s the background.

    For 11 years, I have been here, posting answers and solutions to problems, providing the science and psychophysics behind the science. Thousands of times. Many times, I have given the same explanation, largely because people seem unaware of the rather splendid search facilities here. Never mind.

    Some of the questions have been interesting, some banal, needing only common sense for an answer. I’ve been happy answering them though, because it’s always a pleasure seeing the dawning of understanding. Other forums seem not to work this way, being largely platforms for vested interests to shout at each other. That’s why I stay here.

    But, in the last couple of years or so, things have been changing. Now, the questions are more along the lines of ‘you’ve got it wrong because…’, and some of the posters and postings are clearly biased for/against individual cameras and/or manufacturers.

    I have always been totally neutral on such things, I measure and report. My neutrality has often been questioned; I’ve been accused of being in the pay of both Sony and Panasonic, so I suppose my neutrality is still observable. It will always remain so.

    The recent furore over the AF101 has been the last straw. I got so angry with the continued blether about it that the fuse finally blew. So, here’s my statement for the future:

    I WILL NO LONGER READ, OR REPLY TO, ANY COMMENTS ON ANY CAMERA, FOR ANY REASON.

    If you want to talk rubbish about cameras, get on with it, I won’t comment either way.”

Leave a Reply to Alex FG Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.