I was sent a couple of Adaptimax lens mount adapters to test on my PMW-F3. I have used some of their EX3 adapters in the past and these worked very well. The new PMW-F3 adapters are finished with a very nice hard black anodised finish and look very smart indeed. I had 3 adapters to try, one F3 to Canon and two F3 to Nikon adapters. The Canon adapter is a "dumb" adapter, so there is no way to control the lenses iris. If your using Canon lenses this means using a DSLR body to set the iris before using the lens on the F3. Obviously this is not ideal, but you do have to consider that there is a massive range of lenses that can be used with this Canon adapter via a secondary adapter ring.
Canon's flange back distance (the sensor to lens distance) is the shortest in the DSLR world. So this means that there is space to adapt to other lens mounts with longer flange back distances such as M42, Nikon, Pentax, Pentacon etc. This opens up a whole world of possibilities as now you can use those nice M42 Zeiss lenses that can be picked up cheap on ebay by adding a cheap M42 to Canon adapter.
If you have already invested in Nikon fit glass then you can use a Nikon to Canon adapter or you can use one of Adaptimax's purpose built F3 to Nikon adapters.
There are two varieties, the original Adaptimax and the Adaptimax Plus. The Plus version includes a long screw that pushes the iris pin on the rear of the lens to give you iris control even when the lens does not have an iris ring. While this is not as elegant as MTF Services rotating adapter barrel, it works fine and the simplicity of the design means the adapter is a little cheaper. The standard version has no iris control, so you need to ensure your lens has a proper iris ring. Priced at £255 for the standard adapters and £265 for the plus versions these are good value for money.
Talk about lenses and lens adapters here.
1 post • Page 1 of 1