Sonnet SDHC to SxS Camera Adapter.

I recently reviewed the rather excellent Sonnet QIO I/O device that allows you to very quickly ingest material from SxS cards, P2 cards as well as SD cards to your computer. Along with the QIO I was sent a Sonnet SDHC to SxS card adapter to take a look at. Now I’m going to lay my cards on the table here and say that I strongly believe that if your going to shoot with an XDCAM EX camera you should be using SxS cards in order to get the best possible reliability. However as we all know SxS cards are expensive, although a lot cheaper now than they used to be, I remember paying £600 for an 8Gb card only 4 years ago!

So ever since the launch of the XDCAM EX cameras, users including me have been trying to find alternative recording solutions. I found that it was possible to use an off-the-shelf SD card to express card adapter (the original Kensington Adapter) to record standard frame rates on class 6 SD cards in the EX cameras.  However the SDHC cards stick out of the end of the generic adapters so you can’t close the doors that cover the card slots in the cameras. Following that initial discovery various companies have brought out flush fitting adapters that allow the use of SDHC cards. Then about two years ago Sony openly admitted it was possible to use an adapter in the cameras and released their own adapters (MEAD-SD01 and MEAD-MS01) as well as making some firmware changes that made using adapters more reliable. The key point to consider when using an SxS adapter and SD cards is that the media, the SD cards, are consumer media. They are produced in vast quantities and the quality can be quite variable. They are not made to the same standards as SxS cards. So I choose to shoot on SxS whenever possible and I’ve never had a single failure or unexplained footage loss. BUT I do carry a couple of adapters and some SD cards in my camera kit for emergencies. You never know when you might run out of media or find yourself in a situation where you have to hand over you media to a third party at the end of a shoot. SDHC cards are cheap and readily available. You can buy an SDHC card just about anywhere. I’d rather switch to SDHC cards than try to do a panic off-load to a backup device mid-shoot, that’s a recipe for disaster!

Sonnet-SxS-300x295 Sonnet SDHC to SxS Camera Adapter.
Sonnet SDHC adapter for SxS Camera Slot

Anyway… on to the Sonnet SDHC to SxS adapter. It feels as well built as any other adapter on the market. It is mostly metal with plastic end pieces that are made from a nice high quality plastic. I have other adapters that use a very brittle plastic and these can break quite easily, but this one appears to be well made. The SDHC card slots into a sprung loaded slot in the end of the adapter making a reassuringly positive sounding click when it’s latched in place. Once inserted the SDHC card is slightly recessed into the adapter. This is good as it helps prevent the SDHC card from being released from the adapter as you put the adapter into the camera. It means that as you push the adapter into the camera you are pushing on the end of the adapter and not on the SDHC card like some other adapters I have used. To remove the SDHC card you simply push it quite firmly, further into the adapter until you hear another click and it then pops out far enough to be pulled out. This is certainly one of the better made adapters that I have come across.

To test the adapter I used some Transcend class 6 SDHC cards as well as some Integral Ultima Pro class 10 SDHC cards. I used the adapter in my PMW-F3 with firmware version 1.10 as some user have reported problems with other adapters and this firmware revision. I was able to completely fill the cards shooting using S&Q motion at 50fps or 60fps using long and short clips with lots of motion. This is I believe the toughest test for these adapters as the recording bit rate is close to 70Mb/s. I had no issues at all with either type of SDHC card and there was very little delay between finishing a recording and being able to start the next, a good indicator of the cards high performance. I also tested recording very long clips to ensure that there would be no issues when the camera breaks the recording into 4Gb chunks. Again, no problem.

So if you are going to use SDHC cards and an SxS adapter I would suggest you consider the Sonnet SxS adapter. It’s certainly cheaper than the Sony adapter. Sonnet are a large business with a wide range of products and a global distributor and dealer network, so you should have no problem finding a local supplier.

3 thoughts on “Sonnet SDHC to SxS Camera Adapter.”

  1. Hello Alister,
    On the basis of your review, I bought a Sonnet SDHC Adapter for my PMW-EX-1 and have attempted to use it with a variety of cards, from Transcend and Sandisk (Extreme) 16GB. I updated the software to V1.30 but as yet have had no luck at all and get: Unknown media-please change every time. I cannot format the cards as the camera doesn’t see them! Have you any ideas that I might try?

    In anticipation, George Duncan.

    1. As far as I am aware it should work with firmware 1.2 and above. Even a generic PCI Express to SD card adapter should work. Have you tried formatting the cards on a computer using FAT?

  2. I have just bought the Sonnet SDHC adapter for my PMW-EX1 and I have the same problem. I cannot format the cards… the camera does´t see them. Did you manage to solve this problem?

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.