Tag Archives: ice

Shooting in cold weather and shooting snow scenes. Updated.

A couple of years ago I wrote a guide to help people that might have to shoot in the cold.  I’ve recently updated this article and as I know many of you won’t have seen it before I’ve provided a link to the page below

LINK: This article deals with shooting in the cold and how that might effect your camera.

LINK: Some ideas and suggestions for clothing in very cold conditions.

Here also are some tips for shooting snow scenes with conventional gammas. Of course you can also shoot with log or raw, if you do just make sure your exposure is nice and bright for the best results (I’d expose white at around 75% with S-Log2 or S-Log3).

With conventional gammas such as Rec-709 exposing for snow is tricky. You want it to look bright, but you don’t want to overexpose and it’s very easy to end up with a lot of the bright snow in your scene up in the knee or highlights where it will be compressed and loose contrast. This makes the snow look odd as it will have no texture, it can all too easily look over exposed when in fact it is not. In reality, although we often think of snow as bright and white, often you really don’t want to expose it too high.  With Rec-709 if your camera has a high level zebra set them to 90% (Zebra 2 on most Sony cameras). This way you will get a zebra pattern on the snow as it starts to enter the compressed knee or highlight area. If you are using Sony’s cinegammas or hypergammas I would lower the highlight zebras to 80% -85%.

On overcast or flat light snow days I prefer not to use Hypergammas/Cinegammas  as the highlight roll off can make the snow look very flat unless you grade the images a little and boost the contrast in post. However on bright high contrast snow days with clear skies and strong shadows the Hyoegammas/Cinegammas work very well. You may want to consider using a little bit of negative black gamma to put a bit more contrast into the image.

You also want your snow to look white, so do a manual white balance using a proper white card or better still a grey card. Don’t try to white balance off the snow itself as snow can reflect a lot of blue light and skew the white balance a bit.  If you are shooting during golden hour at the beginning or end of the day and want to retain that warm look you might want to use a 5600K preset rather than a manual white balance.

If the overall scene is very bright you may need to watch your aperture. In most cases you don’t want to have the camera stopped down to an aperture of f11 or smaller.  Due to an effect called diffraction limiting, in HD, at f11 a 2/3″ camera will start to show a slightly soft image.  A 1/2″ sensor camera will be just starting to get slightly soft at f8.  In 4K/UHD a super 35mm camera will start to show a slightly softer image from f11 – f16. So use you ND filters to control you light levels so you do not have too small an aperture. You may need to add additional ND in very bright scenes to avoid diffraction limiting.

One last tip. If you are standing around in the cold and get cold feet you should find something to stand on. Small twigs and branches, a rubber car mat anything like that will help insulate your feet from the cold ground helping keep them warm.

Advertisements

Tips for shooting in very cold weather.

With winter well upon us I thought it would be good to share some of my arctic shooting experience. I’ve shot in temperatures down to -40c in the arctic in winter.

Overall modern tapeless cameras do OK well in extreme cold. The most reliable cameras are larger solid state cameras. Larger cameras cool slower than small ones and larger cameras will hold on to heat generated internally better than small ones.

Condensation:

Condensation is the big deal breaker. When you take the very cold camera inside into a house/hotel/car/tent you will get condensation. If the camera is very cold this can then freeze on the body of camera including the glass of the lens. If there is condensation on the outside of the camera, there will almost certainly also be condensation inside and this can kill your camera.

To prevent or at least reduce the condensation you can place the camera in a large ziplock bag BEFORE taking it inside, take the camera inside in the bag. Then allow the camera to warm up to the ambient temperature before removing it from the bag. Peli cases are another option, but the large volume of the pelicase means there will be more moisture inside the case to condense and the insulating properties of the case mean that it could take many, many hours to warm up.

I don’t recommend storing a cold or damp camera in a Pelicase (or any other similar waterproof case) as there is nowhere for the moisture to go, so the camera will remain damp until the pelicase is opened and everything dried out properly.

Rather than moving a camera repeatedly from outside to inside and repeatedly generating risky condensation you should consider leaving the camera outside. You can leave the camera outside provided it does not get below -25c. Below -25c you risk the LCD panel freezing and cracking. LCD  panels freeze at between -30 to -40c. If you are using a camera in very cold conditions and you notice the edges of the LCD screen going blue or dark you should start thinking about warming up that LCD panel as it may be close to freezing.

LCD displays will become slow and sluggish to respond in the cold. Your pictures may look blurry and smeary because of this. It doesn’t affect the recording, only what you see on the LCD.

Very often in cold regions houses will have an unheated reception room or porch. This is a good place to store your camera rather than taking it inside into the warm. Repeatedly taking a camera from cold to warm without taking precautions against condensation will shorten the life of your camera.
If you can, leave the camera on between shots. The camera generates some heat internally and this will prevent many issues.

BATTERY LIFE:

Li-Ion batteries are effected by the cold but they are not nearly as bad as Nicads or NiMh batteries which are all but useless below freezing. li-Ion battery life gets reduced by between 25 and 50% depending on how cold it is. Down to about -10c there is only a very marginal loss of capacity. Down to -25c you will loose about 20%-30% below -25c the capacity will fall away further.

Keep your spare batteries in a pocket inside your coat or jacket until you need them. After use let the battery warm up before you charge it if you can. Charging a very cold battery will reduce the lifespan of the battery and it won’t fully charge. One top tip for shooting outside for extended periods is to get a cool box. Get some chemical hand warmers and place them in the cool box with your batteries to keep them warm. If you don’t have hand warmers you can also use a hot water bottle.

Watch your breath

If your lens has and snow or ice on it, don’t be tempted to breath or blow on the lens to blow the ice off.  Also try not to breath on the lens when cleaning it as your warm breath will condense on the cold glass and freeze.  Also try to avoid breathing out close to the viewfinder. A small soft paint brush is good for keeping your lens clean as in very cold conditions you’ll simply be able to brush and snow or ice off. Otherwise a large lens cloth.

Covers.

Conventional rain covers become brittle below about -15c and can even shatter like glass  below -20c. Special insulated cold weather covers often called “polar bears” can be used and these often have pockets inside for chemical heat packs. These are well worth getting if you are going to be doing a lot of arctic shooting and will help keep the camera warm. As an alternative wrap the camera in a scarf or cut the sleeves of an old sweater to make a tube you can slide over the camera. If you have a sewing machine you could make a simple cover out of some fleece type material.

Your lens will get cold and in some conditions you will get frost on the front element. To help combat this wrap some insulating fabric around the body of the lens. Wrist sweat bands are quite good for this or an old sock with the toes cut off.

Brittle Plastic.

Plastics get brittle at low temperatures so be very gentle with anything plastic, especially things made from very hard, cheap plastic. The plastic Sony use appears to be pretty tough even at low temps. Wires and cables may become ridged. Be gentle, bend then too much and the insulation may split.

Other considerations are tripods. If outside in very low temps for more than 30mins or so the grease in the tripod will become very thick and may even freeze, so your fluid damping will become either very stiff or freeze up all together. Contact your tripod manufacturer to see what temperatures their greases can be used over. Vinten and some of the other tripod companies can winterise the tripod and replace the normal grease with arctic grease.

Looking after yourself.

I find that the best way to operate the camera is by wearing a pair of large top quality mittens (gloves are next to useless below -15c), consider getting a pair of Army surplus arctic mittens, they are very cheap on ebay and will normally have an additional “trigger finger”. This extra finger makes it easier to press the record button and things like that.  If you can get Swedish or Finnish military winter mittens, these are amongst the best. I wear a pair of thin “thinsulate” gloves that will fit inside the mittens, i can then slip my hands in and out of the mittens to operate the camera.

I keep a chemical hand warmer inside the mittens to warm my fingers back up after using the camera. The hardest thing to keep warm is your feet. If you’ll be standing in snow or standing on ice then conventional hiking boots etc will not keep your feet warm. A Scandinavian trick if standing outside for long periods is to get some small twigs and tree branches to stand on and help insulate your feet from the cold ground. If your feet get cold then you are at risk of frostbite or frost nip. Invest in or hire some decent snow boots like Sorel’s or Baffin’s. I have an arctic clothing guide here; Arctic Clothing Guide |