So you have just taken delivery of a brand new PXW-FX9. Turned it on and plugged it in to a 4K TV or monitor – and shock horror there are little bright dots in the image – hot pixels.
First of all, don’t be alarmed, this is not unusual, in fact I’d actually be surprised if there weren’t any, especially if the camera has travelled in any airfreight.
Video sensors have millions of pixels and they are prone to disturbance from cosmic rays. It’s not unusual for some to become out of spec. So all modern cameras incorporate various methods of recalibrating or re-mapping those pesky problem pixels. On the Sony professional cameras this is called APR. Owners of the Sony F5, F55, Venice and FX9 will see a “Perform APR” message every couple of weeks as this is a function that needs to be performed regularly to ensure you don’t get any problems.
You should always run the APR function after flying with the camera, especially on routes over the poles as cosmic rays are greater in these areas. Also if you intend to shoot at high gain levels it is worth performing an APR run before the shoot.
If your camera doesn’t have a dedicated APR function, typically found in the maintenance section of the the camera menu system, then often the black balance function will have a very similar effect. On some Sony cameras repeatedly performing a black balance will active the APR function.
If there are a lot of problem pixels then it can take several runs of the APR routine to sort them all out. But don’t worry, it is normal and it is expected. All cameras suffer from it. Even if you have 1000 dead pixels that’s still only a teeny tiny fraction of the 19 million pixels on the sensor.
APR just takes 30 seconds or so to complete. It’s also good practice to black balance at the beginning of each day to help minimise fixed pattern noise and set the cameras black level correctly. Just remember to ensure there is a cap on the lens or camera body to exclude all outside light when you do it!