# FX6 and FX9 R and B Gain values – don’t worry about the odd numbers.

I’ve noticed some users concerned or confused by the R and B gain values that they see in the cameras white balance settings after dialling in a custom white balance and tint, or after taking a white balance from a white card. The R and B gain values indicate the offset that is being applied to the Red and Blue channels relative to the Green channel and in fact they are perfectly normal.

Typically the concern occurs when someone has used a white card to set their white balance and then these seemingly random numbers appear against the Red and Blue gain. But they are not random, they are expected, normal, and not normally something to every worry about.

The FX6 and FX9 are set up such that the indicated Red and Blue gains will only ever both be 0 when the white balance of the camera is at exactly 3200K. At any other white balance there will be an offset to the R and B gain – and that is completely normal. It is these offsets that balance the Red and Blue levels so that the white balance appears correct. At a lower colour temperature you will see a positive blue value and a negative red value. Above 3200K there will be a positive Red value and a negative Blue value.  A positive tint value will make both the Red and Blue more positive and a negative tint value will make both the Red and Blue values more negative.

All of this is perfectly normal and perfectly expected. If you have taken a white balance off a white card and then dial in a preset value you might find that the you can’t get the last  2 digits back to a zero.

For example after white balancing off a card you have 3653K but you then try to dial in 3200K, but the closest you can get is 3193K or 3213K.  This is because the smallest steps the colour temperature changes in is 20K (on the FX6 above 5640K the steps gradually get larger and larger). But this really isn’t something to worry about 3193K or 3213K are both so close to 3200K that either will do and calibration  and temperature differences will mean that the actual variations between different cameras or the camera and a colour meter will be greater than this error anyway. No two cameras will ever be truly identical and differences between lenses will cause add to this normal variation. There is no need to worry about the last 2 digits not being zero’s.

At the end of the day, these tiny differences are not something to worry or be concerned about. But if you do want to return the last digits back to zero you can do this by dialling the white balance all the way down to 2000K.

## 5 thoughts on “FX6 and FX9 R and B Gain values – don’t worry about the odd numbers.”

1. George Griswold says:

Under 3200 should be +blue not minus

2. Hi Alister,
Thanks for the very helpful article on R and B Gain values.
As I shoot in Log I use the Preset, A and B white balance settings set to 3200k, 4300K and 5600K. Does it make a difference (on an FX9) which value is set as the preset white as there is no control of the the Tint, R and B Gain values in the Preset position?
In your article you do not mention the Tint values so am I right to assume these should typically be set to 0 regardless of the colour temperature and R and B Gain values?

1. alisterchapman says:

Tint should be zero unless you need to introduce a green/magenta tint.

3. Alexander Sharkey says:

Hi Alister,
Somewhat unrelated, but any idea why the fx30 can’t go below 2500k down to 2000k? In theory the fx3/30 should be able to match the fx6/9. Another OS limitation of the sub-fx6 line?

1. alisterchapman says:

Different firmware, different processing, lots of reasons, they are not the same cameras.

This site uses Akismet to reduce spam. Learn how your comment data is processed.