This seems to be a source of frustration for many people shooting raw or using S-Log2 or S-Log3 on a Sony camera. When shooting log and raw you should also be using a matching S-Gamut colour gamut if you want to get the best from the camera and this ties you into one of 3 preset white balances.
With a PXW-FS7, PMW-F5 or F55 it is possible to use custom mode to select a different colour space to mix with S-Log2 or S-Log3 and then have a variable white balance. With the Alpha cameras, PXW cameras such as the FS5 you can choose any Gamut you want in the picture profiles, but I don’t recommend this. For a start, if you don’t use one of the S-Gamuts you will be limited to Rec-709 Gamut, so you won’t be recording the cameras full colour range. Also in custom mode there are some other things like noise reduction that you really don’t want when shooting S-log2/3 (it can cause banding).
So why is the S-Gamut white balance fixed to the 3 presets for daylight, fluorescent and tungsten? The main reason is to ensure you get the cameras full dynamic range in each colour. White balance is a gain function, it adjusts the gain of the red, green and blue channels so that white objects appear white under differing light sources. So if the light source lacks blue light – making the pictures look excessively warm – you add extra gain to the blue channel to compensate.
But the problem with this is that gain affects dynamic range. When shooting log (or raw) the camera needs to operate the sensor at the optimum gain level to squeeze the highest possible dynamic range from the it. Changing the gain in just one colour channel to shift the white balance could result in a reduction of dynamic range in the channel. This could manifest itself as colours in one channel that clip sooner than the others. This can be really hard to deal with in post production and can show up as things like bright clouds with a colour cast that isn’t in the rest of the picture.
Another potential issue is that because of the way silicon sensors work the blue channel is almost always noisier than the red and green. So you want to keep the gain in the blue channel as low as possible to prevent the pictures getting too noisy. This is particularly important when shooting log as you won’t see your end result until after the images have been graded. So manually shifting the gain of the blue channel in camera to correct the white balance could lead to footage that ends up noisier than you would expect.
So – Sony chose to fix the white balance to 3 carefully tuned presets designed to avoid this situation and maximise the dynamic range. After all, when shooting log or raw it is expected that the footage will be graded anyway, so the white balance will normally be adjusted as part of the post production process.
There are some people that advocate adjusting the FS5’s white balance via the picture profile settings, personally I don’t recommend this or feel that it’s necessary. But yes, you can do this, but just keep a very close eye on your highlights and if you can use monitor with RGB parade to make sure you have equal recording levels for your whites without one colour channel clipping ahead of the others. Also apply a LUT in the monitor that is close to your desired output so that you can keep an eye on the noise levels.
In summary – the white balance is preset to ensure you don’t encounter problems later on. You should be able to fully adjust and fine tune your white balance in post production to a far greater degree than is possible in camera anyway, so don’t worry if the WB is a touch off when shooting.
The only exception to this is the new Sony Venice. Venice has enough dynamic range and enough internal processing power to allow you to make a wide range of white balance adjustments in camera. Hopefully we will see some of this flexibility trickle down to the next generations of lower cost Sony digital cinema cameras.
